Inxpect SRE 200 Series - 9.3 INFO events

To Next Page

To Previous Page

CONTROLUNIT Detection exit (field #n)

SENSOR #k Detection exit

9.3 INFOevents

9.3.1 System Boot

Every time the system is powered up, the event is logged reporting the incremental count of the boot from the

beginning of the life of the device.

Format: System Boot #n

Example:

0 2020/11/18 16:47:25 [INFO] CONTROLUNIT SYSTEMBOOT #60

9.3.2 System configuration

Every time the system is configured, the event is logged reporting the incremental count of the configuration from

the beginning of the life of the device.

Format: System configuration #3

Example:

20 2020/11/18 16:47:25 [INFO] CONTROLUNIT System configuration #3

9.3.3 Factory reset

Every time a factory reset is required, the event is logged.

Format: Factory reset

Example:

20 2020/11/18 16:47:25 [INFO] CONTROLUNIT Factory reset

9.3.4 Stop signal

If configured, every change of the Stop Signal is logged as ACTIVATION or DEACTIVATION.

Format: Stop signal ACTIVATION/DEACTIVATION

Example:

20 2020/11/18 16:47:25 [INFO] CONTROLUNIT Stop signal ACTIVATION

9.3.5 Restart signal

If configured, every time the system is waiting for the restart signal or the restart signal is received, the event is

logged as WAITING or RECEIVED.

Format: Restart signal WAITING/RECEIVED

Example:

20 2020/11/18 16:47:25 [INFO] CONTROLUNIT Restart signal RECEIVED

9.3.6 Detection access

Every time motion is detected, a detection access is logged with additional parameters depending on the

selected verbosity level: the detection field number, the sensor which detected the motion, the detection

distance (in mm) and the detection angle (°) (see "Verbosity level for detection access and exit events" on the

previous page).

Format: Detection access (field #n, distance mm/azimuth°)

9. Troubleshooting