Inxpect SRE 200 Series

To Next Page

To Previous Page

3.1.3 Main components

Inxpect SRE 200 Series is composed of a control unit and up to six sensors. The Inxpect Safety application allows

system operation configuration and checks.

3.1.4 Control unit and sensor compatibility

The models and types of control unit and sensors are shown below, with their compatibility.

Each control unit, updated to firmware version 2.0.0, can communicate with any sensor.

NOTICE: do not connect the control unit with other types of sensors (e.g., 9 meters range sensors).

The control unit can be simultaneously connected to both 3.x sensors and 5.x sensors. For more details about the

available features, see " Sensors" on page26.

3.1.5 Control unit - sensor communication

The sensors communicate with the control unit via CAN bus using diagnostic mechanisms in compliance with

standard EN 50325-5 to guarantee SIL 2 and PL d.

For correct functioning, each sensor must be assigned an identification number (Node ID).

Sensors on the same bus must have different Node IDs. By default, the sensor does not have a pre-assigned

Node ID.

3. Get to know Inxpect SRE 200 Series

Inxpect SRE 200 Series - Page 15