Inxpect SRE 200 Series - Page 96

96
Inxpect SRE 200 Series| Instruction manual v1.5 DEC 2023 |Inxpect SAF-IM-200S_5m_7_00047_en_v1.5|© 2021-2023 Inxpect SpA
9. Troubleshooting
9.4.4 Peripheral error (PERIPHERAL ERROR)
Error detected by diagnostics relative to the micro-controller, its internal peripherals or memories.
9.4.5 Configuration errors (FEE ERROR)
Indicates that the system must still be configured. This message can appear when the system is first turned on or
after reset to default values. It can also represent another error on the FEE (internal memory).
9.4.6 Output errors (OSSD ERROR)
Error Meaning
OSSD 1 SHORT-
CIRCUIT
Short-circuit error on MOS output 1
OSSD 2 SHORT-
CIRCUIT
Short-circuit error on MOS output 2
OSSD 3 SHORT-
CIRCUIT
Short-circuit error on MOS output 3
OSSD 4 SHORT-
CIRCUIT
Short-circuit error on MOS output 4
OSSD 1 NOLOAD No load on OSSD 1
OSSD 2 NOLOAD No load on OSSD 2
OSSD 3 NOLOAD No load on OSSD 3
OSSD 4 NOLOAD No load on OSSD 4
9.4.7 Flash errors (FLASH ERROR)
A flash error represents an error on the external flash.
9.4.8 Dynamic configuration error (DYNAMIC CONFIGURATION ERROR)
A dynamic configuration error indicates an invalid dynamic configuration ID.
9.4.9 Internal communication error (INTERNAL COMMUNICATION ERROR)
Indicates that there is an internal communication error.
9.4.10 Input redundancy error (INPUT REDUNDANCY ERROR)
Error Meaning
INPUT 1 Error in the redundancy on Input 1
INPUT 2 Error in the redundancy on Input 2
ENCODING Invalid encoding when the encoded channel option is enabled
PLAUSIBILITY 0->1->0 transition not compliant with input functionality specification
9.4.11 Fieldbus error (FIELDBUS ERROR)
At least one of the inputs and outputs has been configured as Fieldbus controlled, but the Fieldbus
communication is not established or not valid.
Error Meaning
NOTVALIDCOMMUNICATION Error on the Fieldbus
9.4.12 RAM error (RAM ERROR)
Error Meaning
INTEGRITY ERROR Wrong integrity check on the RAM