here < 10ms + 10ms = 20ms
The "Character Distance" is the maximum distance between two character
received. If this value is exceeded, all characters received until then are sent on
the PC. The blocking function does not directly affect the application, but it can
help reduce the network load. Only in very few cases does the default value of 5
ms require adjusting.
r "Application Programing Interface“ (API) is identical to the serial
ith
32. All functions are available, but the timing might be slightly different.
UART
smission speeds between 2400 baud and 115200 baud.
ight result in data loss if data is transmitted continuously.
throughput time + 10ms = ideal “Total Timeout“
Windows API
The drive
Windows driver, enabling all applications which use this interface, to work w
ipEther2
The UART supports tran
Higher baud rates m
7 or 8 data bits can be used.
The parities "none“, "even“, "odd“, "1“ and "0“ are supported.
7 bit data does not support the parity "none".
Änderungen vorbehalten Stand 09.09.05
ipcas GmbH ipEther232 V11.01 Seite 44 von 150
To Next Page
Loading...