IpCAS ipEther232 - Modem Behavior Settings

Modem settings:
Here you can define the modem behavior.
„Answer incomming calls“: Atomatic call accept.
„local Echo on“: Command echo on.
„Quiet Mode“: Result codes on.
„Ignore DTR“: ignore DTR status change.
„RS485 (Half Duplex)“: Half Duplexcontrol for RS485 with Bussystem. During the
sending process to the serial interface the receiving device is switched off. All
ata received at this time is ignored (RS485 as a 2 wire solution).
nable Password protection“ Enable or disable serial password protection for
onnection passwords.
d
„E
c
Änderungen vorbehalten Stand 09.09.05
ipcas GmbH ipEther232 V11.01 Seite 57 von 150