S0 Automatic Call Accept
0..9
0
anent memory AT&W
yo n set the 0 > 0,
tomatical
gs the modem waits it auto answers.
t within t enters
al minimum r of
a f, for inst dem
tom cally enters
S2 Esc
ange 0..255 decimal
43 (+)
permanent memory AT&W
'+++', allowing you to
ock th switchover to the command mode.
S3 Carr
0..127 decimal
13 (Carriage Return)
nt memory AT&W
S4 Linefee
he S4 register defines the linefeed character.
S5 Bac ce Character
ange 0..32, 127 decimal
efault 8 (Backspace)
tore in permanent memory AT&W
he S5 register defines the Backspace character.
Range rings
Default
Store in perm
In the
each incomin
S0 register,
g call is a
u ca
u
automatic call accept (auto answer). If S
ly answered. The value in S0 defines the
efore number of rin b
If the entered value is no he valid range, the modem automatically
e numbethe ne
ngs t
xt possible v
modem w
ue (
. I
or maximum value) defining th
ri
au
he
ati
its
9.
ance, you enter 10 in Germany, the mo
S1 Ring Counter
Range 0..255 rings
Default 0
Store in permanent memory no
The S1 register contains the number of rings of an incoming call. The value in S1
is reset to zero, if no rings have arrived for a time span specified in the S99
register (default 5 seconds). During this time new incoming calls cannot be
distinguished and the modem cannot dial.
ape Code Character
R
Default
Store in
In the S2 register, you can define the Escape command
switch from data mode to command mode.
Values equalling 0 or >128 bl e
iage Return Character
Range
Default
Store in permane
In the S3 register, you can define the Return character.
d Character
Range 0..127 decimal
Default 10 (Linefeed)
Store in permanent memory AT&W
T
kspa
R
D
S
T
Änderungen vorbehalten Stand 09.09.05
ipcas GmbH ipEther232 V11.01 Seite 72 von 150
To Next Page
Loading...