S30 Inactive Timer
seconds)
off)
tore in permanent memory AT&W
the S30 register, you can set the time span the modems waits before it kills the
onnection automatically, if there has been no reception or transmission of data
ables the inactive timer.
S31 Ba
efault 3 ( = 9600 Baud)
the S31 register, you can set the Baud Rate. The baud rate defines the
nges of the transmitted signal per second.
=2400 2=4800 3=9600 4=19200 5=38400 6=57600 7=115200)
S32 Pa
y)
tore in permanent memory AT&W
register, you can set the parity bit for error detection in the case of
O s
th is even and vice versa for odd parity.
S33 Da Bits
ange 7..8
efault 8
ory AT&W
S34 Stop Bits
tore in permanent memory AT&W
ber of stop bits. One or two bits in
synchronous transmission, indicating the end of a data word (packet).
Range 0..255 (10
Default 0 (timer
S
In
c
in the meantime. 0 dis
ud Rate
Range 1..7
D
Store in permanent memory AT&W
In
number of state cha
(1
rity
Range 0..4
Default 0 (no parit
S
In the S32
asynchronous data transmission. Part of the data transmission format.
ccasionally no parity, constantly one (mark) or zero (space). Even parity mean
at the bit is set, if the data bit number
0=None 1=Even 2=Odd 3=Mark 4=Space
ta
R
D
Store in permanent mem
In the S33 register, you can set the number of data bits.
7=7 Bits 8=8 Bits
Range 1..2
Default 1
S
In the S34 register, you can set the num
a
1=1 Stop Bit 2=2 Stop Bits
Änderungen vorbehalten Stand 09.09.05
ipcas GmbH ipEther232 V11.01 Seite 73 von 150
To Next Page
Loading...