S35 Rxd Timeout (Total Read Time
Änderungen vorbehalten Stand 09.09.05
ipcas GmbH ipEther232 V11.01 Seite 74 von 150
out)
gister, you can set the Total Read Timeout.
fter the first byte has been received, "Total Read Time" starts. After it has
xpired, all characters received so far are sent to the PC. This value must not be
the delay of the UDP packet in the Ethernet. You can use the "ping"
ol to determine the throughput time.
S36 Ch nce)
e Character Distance.
the time span between two received characters (bytes) is greater than the
efined Character Timeout, all bytes received so far are sent to the Ethernet.
fter the Char-Timeout all received characters until there are sent to the PC. This
alue must not fall below the travel time of the udp packet in the Ethernet. Use
e "ping" tool to determine the travel time.
S37 Bit Options
ange 0..255
efault 5 (binary: 0000 0101)
tore in permanent memory AT&W
the S37 register, you can set the bit options echo, quiet, DTR, verbose, half-
uplex controlling
Range 5..255 ms
Default 100 ms
Store in permanent memory AT&W
In the S35 register, you can set the Total Read Timeout.
After the first byte has been received, "Total Read Time" starts. In the S35
re
A
e
lower than
to
ar-Timeout (Character Dista
Range 5..255 ms
Default 100 ms
Store in permanent memory AT&W
In the S36 register, you can set th
If
d
A
v
th
R
D
S
In
d
To Next Page
Loading...