6. Press
RETURN
.The entry below appears.
a: base; (1) size; (150)
Press
RETURN
to accept this entry. This entry indicates that partition
md0a begins at cylinder 1 and has a size of 150 cylinders.
Partition md0a is the root partition and does not change.
7. To add 100 cylinders to the swap partition (md0b), 100 cylinders
must be subtracted from the user partition (md0c). The base, or
beginning, of partition c changes by 100 cylinders. Type the revised
entries after the numbers in parentheses:
Vertex:
b: base; (151) size; (149)249
c: base; (300)400 size; (586)486
Maxtor:
b: base; (151) size; (149)249
c: base; (300)400 size; (670)570
8. Continue to press
RETURN
until the workstation displays the Set?
prompt.
9. Enter q twice to quit both the set function and mdfex. The
workstation displays the mdfex prompt and the message:
Quit
Label on drive 0 needs updating... do it?
10. Confirm your intention to update the drive label by entering y. The
workstation displays the message:
--confirm quit with ‘y’:
11. Type y to confirm your intention to quit mdfex and return to the
PROM monitor. The PROM monitor prompt appears.
12. Boot the system in single-user mode:
b
Version 1.1 SERIES 3000
IRIS OWNER’S GUIDE 6-5 Disk Conguration
To Next Page
Loading...
General