4JB1/4JB1T/4JB1TC/4JG2 – ENGINE 6A1 – 97
1. Transmission and Clutch Assembly
• Raise vehicle and support with suitable safely.
1) Transmission
!
Propeller Shaft
• Reference mark the flange yoke to the parking brake
drum.
• Disconnect the propeller shaft at flange yoke.
• Put aside the propeller shaft and tie it to the frame so
that it does not interface with servicing work.
"
Parking Brake Cable
• Move the joint cover.
• Disconnect the joint bolt.
• Remove the clip then disconnect the cable from the
bracket.
#
Wiring Connector
• Disconnect the wiring connectors from the car speed
sensor, the neutral switch and the back-up light switch.
$
Shift Cable and Select Cable
• Disconnect the shift cable and select cable on the
transmission side.
6A1-97-1.tif
6A1-97-2.tif
6A1-97-3.tif