ITech IT7900P Series - Menu Function

System-Related Functions
Copyright ©ITECH Electronic Co., Ltd. 107
trigger signal.
(This configuration is displayed only
when the IO pin is set to Trigger1-out)
Digital IO-7: TRIG2
Function setting of pin 7
Reverse
On/Off
Fun
⚫ Trigger1-out
⚫ Trigger1-in
⚫ Input
⚫ Output
AC
On/Off: When On is selected, a trigger
signal is output when AC amplitude
changes. The accuracy of voltage change
is 100mV and is not restricted by phase.
(This configuration is displayed only
when the IO pin is set to Trigger2-out)
DC
On/Off: When On is selected, a trigger
signal is output when the DC amplitude
changes, and the voltage change
precision is 100mV.
(This configuration is displayed only
when the IO pin is set to Trigger2-out)
Freq
On/Off: When On is selected, a trigger
signal is output when the frequency
changes.The accuracy of frequency
change is 0.1Hz
(This configuration is displayed only
when the IO pin is set to Trigger2-out)
List
On/Off: When On is selected, the List
generates a trigger signal and outputs a
trigger signal.
(This configuration is displayed only
when the IO pin is set to Trigger2-out)
Information
Product model
Display the instrument model.
Serial number
Display the serial number.
Software version
Display the control board version.
MAC address
MAC address
7.1.1 Menu function
Set OFF Mode Status
This parameter is used to set the status after the power output is off.
⚫ Select to High-Z, After the power output is Off, the dc impedance between
the terminals of the power supply is high, and the resistance value varies
with different models.
⚫ Select to Short, When the power output is Off, the terminals of the power
supply are short-circuited, the voltage is 0.
⚫ Select to Open-Z, After the power output is Off, the power supply is in open
mode, and the internal circuit and external load of the power supply are
disconnected by relay.
Set the keyboard sound
This item can set the key sound state. If in ON mode, then when you press a