Overview
Copyright ©ITECH Electronic Co., Ltd. 9
Chapter1 Overview
This chapter introduces the front panel, the rear panel, key functions and LCD
display function of the IT7900P series power supply, make sure that you can
quickly know the appearance, instruction and the key function before you
operate the power supply. Help you make better use of this series of power
supply.
1.1 Brief Introduction
ITECH IT7900P series represents a new generation of programmable, full power
source and sink 4-Quadrant grid simulators and also can perform as a 4-
Quadrant power amplifier, providing the flexibility to test widest range of grid-tied
devices, including PCS, energy storage systems, micro grids, BOBC (V2X) and
power-related hardware in the loop emulation (PHiL).
The IT7900P series is equipped with a professional anti-islanding test mode,
allowing the user to set R, L, C and active and reactive power parameters to
simulate non-linear loads on the grid and achieve anti- islanding testing
requirement. The IT7900P series supports energy recovery function that
provides 100% current absorption and feeds back into local grid through the
device, saving electricity bills and heat dissipation costs.
ITECH IT7900P Regenerative Grid Simulator adopts high power density design
of 15kVA in 3U enclosure and provides wide voltage ranges up to 350V L-N.
Easily expandable by Master-slave parallel configuration for higher power up to
960kVA. Comprehensive options of operating modes can meet users'
requirements for single-phase, three-phase, reversed-phase and multi-channel
testing requirements. Extended AC voltage range to 700V L-N enabled by
reversed mode. The powerful arbitrary waveform editing function can simulate
a variety of grid disturbance waveforms, which is an ideal solution for testing and
R&D laboratories.
1.2 Models and Options
To Next Page
Loading...
