System-Related Functions
Copyright ©ITECH Electronic Co., Ltd. 113
7.5 Save and Recall Operations
The power system can save up to 10 common parameters in nonvolatile
memory (No. 1 to No. 10) for user to recall conveniently.
The saved parameters include:
⚫ Power supply mode
⚫ Present output mode
⚫ Config menu settings
You can do the save and recall operations by the following two methods.
⚫ Press the composite keys [Shift]+[4] (Save) to save the parameters.
Pressthe composite keys [Shift]+[5] (Recall) to recall the parameters.
⚫ SCPI commands: *SAV and *RCL
Save Operation
The save operation procedures are as follows:
1. Press the composite keys [Shift]+[4] (Save) to enter the parameter save
interface.
2. Select the storage location. up to 10 position can be select. ( The screenshot
in Source mode is used as an example. The display in Load mode is
different)
3. Press [Enter] to save the parameters.
Finished, the saved parameters will be display at the bottom of the interface.
Recall Operation
You can recall the parameters you saved in the specified memory location as
the setting values.
1. Press the composite keys [Shift]+[5] (Recall) to enter the parameter
recallinterface.
2. Set the storage location.
Press the direction keys to set the storage location, and then, the saved
parameters will be display at the bottom of the interface.
To Next Page
Loading...
