ITech IT7900P Series User Manual

Getting Started
Copyright ©ITECH Electronic Co., Ltd. 36
The meter interface of phase A is shown as follow, the display parameters are
the same as single mode. You can click the A, B or C to switch the phase
interface.
Introduction to Interface Symbols
The interface of IT7900P power supply will display the following symbols. All the
symbols and description are listed in the table below.
Char
Function description
Char
Function description
Shift
Compound key
Output is off
Output is on
Key operation is
locked
Single phase AC mode
Three phase AC mode
Single phase DC mode
Three phase AC+DC
mode
Split phase AC mode
Split phase AC mode
Split phase AC+DC mode
Split phase DC+AC
mode
Single phase DC+AC
mode
Single phase AC+DC
mode
Multi-channel AC mode
Multi-channel AC+DC
mode
Multi-channel DC mode
Multi-channel DC+AC
mode
The AC source is in
remote mode
Surge&Sag function
indicator
External Simulation Test
Function
Record log
LIST is running
LIST is finished

ITech IT7900P Series Specifications

General

Brand	ITech
Model	IT7900P Series
Category	Power Supply
Language	English