iteco IT 10151 - Use of the Machine; Checking before Use; Visual Checking

35
IT10151 - IT12151
OPERATING AND MAINTENANCE HANDBOOK
Use of the machine
Before carry out any operation it is necessary read and well-understand
this handbook along with the instructions described on plates and
adhesive labels.
Checking before use
Before seing at work the machine and carrying out any operation,
the machine itself has to be subjected to a visual and operating check
described here below.
During the seing at work it is also necessary carry out the safety
device checking.
Visual checking
Make sure that the following failures are
NOT occurred:
•Oil leakage from pipes and others hydraulic components.
•Cut or disconnected electric wires.
•Missing or unloosed nut in the wheels.
•Worn or cuts in the wheels.
•Damages, deformations, loosen or missing screws and bolts, cracked
welding on chassis, wheel supports, steering systems, liing systems,
platforms and railings.
Check
•the soil where the platform should operate is solid and able to sup-
port the maximum load per each wheel.
•the operating handbook is on board and plates and adhesive labels
well visible
•the ladder, handrail and the platform are free from grease and oil
traces.
•the working area is free, without holes and uneven grounds.