76
IT10151 - IT12151
OPERATING AND MAINTENANCE HANDBOOK
Inclination
Carry out this test with the machine perfectly levelled, for avoiding
altered values.
Carry out this test by using platform control panel.
Do not stop on platform
Make sure that there are no obstacles above or under platform before
carrying out this test
•Lower platform completely.
•Position a wedge A measuring about 97 mm:
- under each wheel of front axle for rear longitudinal inclination;
drive the machine on it; li platform and carry out tests reported
on the following page;
- repeat the above mentioned test positioning the wedges under
each wheel of rear axle.
During the second test, the machine must be put in the same position
with respect to the ground, while altering the wedge position (See
drawing on the side).
To Next Page
