iteco IT 10151 - Page 77

77
IT10151 - IT12151
OPERATING AND MAINTENANCE HANDBOOK
• Position a wedge B measuring about:
- 45 mm under each le, front and rear wheel for right transversal
inclination; drive machine on it; li platform and carry out follow-
ing tests.
- repeat the above mentioned test positioning the wedges under each
right front and rear wheel.
During the second test, the machine must be put in the same posi-
tion with respect to the ground, while altering the wedge position
(See drawing on the side).
• Check that inclination warning light blinks under SQ1 operating
height
•Li platform and check that above SQ1 operating height:
- inclination warning lights is on.
- the alarm sounds.
- all movements, lowering excluded, are stopped.
•Lower platform under SQ1 operating height and check that all move-
ments have been restored.
Lower platform completely, drive machine forward and remove
wedges.
Carry out tests in all four directions: forward – backward – right-
ward – leward.