Jack 6040-D - Page 64

星火全自动缝纫控制系统使用说明书
Operation Instruction for Xing Huo Automatic Sewing Control System
64
Met
hod
of
Feed
ing
Sewing Thickness Type
Thick/1/2…
Thick
Light-Material Thickness
Thick/1/2…
Thick
Middle-Material Thickness
Thick/1/2…
Thick
heavy-Material Thickness
Thick/1/2…
Thick
Brok
en
Thre
ads
Dete
ction
Broken Threads Detection
Yes/NO
Yes
Whether to enable Broken Threads
Detection function
Cutting for the Broken
Threads
Yes/NO
Yes
Automatic cutting for the broken threads
Ignored Threads When
Sewing
1-255
3
Without broken threads detection for the
first set number of threads
Check Threads of the
Broken
1-255
2
To confirm broken threads after detecting
the set number of threads continuously
Delay When Broken
Threads
0.01-255.00
0.20
Delay setting time and then carry out
broken threads processing after
confirming broken threads
Trim
ming
Setti
ng
Speed of Trimming(rpm)
10-2000
260
Starting Delay of Trimming
0.01-6.55
0.12
Duration of Drawing
Threads
0.01-6.55
0.12
Drawing Threads the
Delay(s)
0.01-6.55
0.12
Delay for Loosening
Threads
0.01-6.55
0.00
If Trims Threads After
Sewing
Yes/NO
Yes
If Open the Wiper
Yes/NO
Yes
Reserve
Yes/NO
Yes
Cou
nting
Setti
ng
Stat. Clearing in turn on
Yes/NO
Yes
Whether to carry out zero clearing to
"Initial Len of Bobbin Thread" in
processing statistics page when
electrifying
Stop After the Counter
Reaches
Yes/NO
Yes
Whether to stop processing when the
"Initial Len of Bobbin Thread" is equal to
"Total Len"
Effective Setting of the
Counter
Yes/NO
NO
"Yes" will enable the bobbin thread
statistical function always
"No" is to control the bobbin thread
statistical function by
Init
Needles to the UP Pos.
Yes/NO
Yes