Jack 6040-D - User Settings Parameters Introduction

星火全自动缝纫控制系统使用说明书
Operation Instruction for Xing Huo Automatic Sewing Control System
61
6.2 User Settings Parameters Introduction
Para
mete
r
Clas
sific
ation
Parameter Name
Scope
Default
Value
Parameter Meaning and Note
Auto
Proc
essin
g
Setti
ng
Uplifting after Work End
Yes/NO
NO
Constant Speed Mode
Main
Axis/Feedin
g
Feeding
(Fixed)
Trimming after Work End
Yes/NO
Yes
To the Pos. after Work End
Original
Pos./Sew
Pos.
Sew Pos.
"Origin" is the origin of the absolute
coordinates;
"
S
econdary origin" is the secondary origin
(offset point) adding to file
After Sew Loosening
Yes/NO
NO
(Fixed) Whether always loosing threads
in sewing empty offset
Auxiliary Pos. for
Processing
Yes/NO
NO
Start Threads Repeat
Close/1/2
Close
"1", "2" mean at the beginning of sewing,
sew the first needle position repeatedly for
once or twice and then sew the next needle
position.
"Off" is not repeat sewing.
Threads for Loosening
0~255
0
Nee
dle
Start
ing
Spee
d
Speed of the First Stitch
100-3000
300
(Adjust on-demand)
Accelerate from stationary to maximum
sewing speed, which can be divided into 5
stages of acceleration process at most.
Increasing speed too quickly may result in
stitches of the first few needles becoming
smaller.
Speed of the Second Stitch
100-3000
600
Speed of the Third Stitch
100-3000
1000
Speed of the Forth Stitch
100-3000
1600
Speed of the Fifth Stitch
100-3000
2000
Normal/Slow
Normal
Slow: It means the constant increases, the
above acceleration setting is invalid
Spee
d
Setti
ng
Max_Speed of the Main
(rpm)
100-3000
2800
Restrict maximum operating rotate speed
of the processing main interface.
Space Moving Speed
(mm/min)
100~50000
15000
Movement speed of the presser frame in
empty sending section during normal