What to do if my Jackson TempStar Dishwasher won't fill and the power light is off?
If your Jackson Dishwasher isn't filling after closing the door, and the power light isn't on, check these: * First, reset the service breaker. If it trips again, have an electrician check the machine's amp draw. * Second, ensure the dishwasher is properly connected to the power source. * Third, check the power source wiring and replace the switch if needed.
What to do if my Jackson Dishwasher won't fill but the power light is on?
If your Jackson Dishwasher isn't filling after closing the door, but the power light is on, here's what to check: * The rinse solenoid valve may be faulty; repair or replace it as needed. * The door switch might be faulty; verify its wiring, and replace the switch if the wiring is correct. * The high-level probe could be fouled or faulty; clean it first, and if it still doesn't work, replace it.
Why won't my Jackson TempStar Dishwasher rinse during autocycle?
If your Jackson Dishwasher isn't rinsing during the auto cycle, here's what you should check: * Inspect the rinse solenoid; repair or replace it if it's defective. * Replace the timer if it's faulty. * Make sure the machine is getting water at 10 ± 2 PSI.
Why are dishes not coming clean in my Jackson TempStar Dishwasher?
If your Jackson Dishwasher isn't cleaning dishes properly, focus on these points: * Make sure the incoming water, rinse water, and wash water temperatures meet the required minimums listed on the machine's data plate. * Adjust the detergent concentration to match the amount of water the machine holds.
General| Model | TempStar Series |
|---|---|
| Voltage | 208-240V |
| Number of Wash Cycles | 1 |
| Color | Stainless Steel |
| Category | Dishwasher |
| Voltage Options | 208V, 240V |
| Capacity | 60-80 racks per hour |
| Water Consumption per Cycle | 0.5-1.0 gallons |
| Water Consumption per Rack | 0.84 gallons |
Details warranty terms for parts and labor.
Provides overall physical dimensions of the dishmachine.
Lists voltage, phase, frequency, and circuit requirements.
Steps for safe electrical connections.
Lists common issues and their causes/remedies.
Electrical diagram for Tempstar HH/HH-E (1-Phase).
Electrical diagram for LT/NB models (1-Phase).
To Next Page
