pow.
(*)= The power supply connection depends on the type of receiver and the power supply required
(terminals 2 - 1 for power supplies 24VDC, 24VAC, 115VAC or 3 - 1 for power supplies 12VDC, 48VAC, 230VAC)
(**)= Relay life is increased by the use of surge limiters (ex: RC network for AC, Zener + diodes for DC etc...)
(**)= K1 and K2 contactors must have guided contacts
(**)= Elements wich indicate start of remote controlled machines (ex: horn, rotating / flashing light etc...)
*
**
Safety relays RS1 and RS2 are switched "on" by the pushbutton "ON / Horn", and hold in position until the
stop palmswitch is pressed (active shutdown) or until the loss of the radio transmission (passive shutdown).
To Next Page
Loading...
Need help?
General
