Jay electronique UR Series - Procedure: Locking-Unlocking Access to Programming of URE

UR - 323245J - 71 -FRENDE
électroni que
n°1 n°2
n°3 n°4
DATA
électroni que
n°1 n°2
n°3 n°4
électron ique
n°1 n°2
n°3 n°4
électro nique
n°1 n°2
n°3 n°4
électron ique
n°1 n°2
n°3 n°4
Fig.1 Fig.2
Fig.4 Fig.5 Fig.6
Fig.3
Locking
Unlocking
Key memory
6.3.1 Procedure: "Locking-unlocking" access to programming
of transmitter URE
1- Switch off the receiver.
2- Insert the electronic key in the transmitter unit.
3- - Hold buttons n°1, n°2 and "On/Horn" pressed while unlocking the stop palmswitch
button (fig.1).
4- Wait until the orange indicator goes off before releasing buttons n°1, n°2 and "On/
Horn".
Indicator lights statuses:
- transmitter locked : orange indicator light on, green indicator light off
- transmitter unlocked : orange and green indicator lights on.
5- Select "locked" or "unlocked" by pressing button n°2; the selected mode is shown by
the indicator lights (fig.2&3).
6- Validate the selected mode by pressing the "On/Horn" button (fig.4).
7- The transmitter saves the new mode in the electronic key and switches off the indicator
lights.
8- Exit the "locking - unlocking" configuration mode by pressing the stop palmswitch button
(fig.6).
Caution: If an operator attempts to program the frequency or the "dead man" function
time or an electronic key identity code copy, with the transmitter locked, the
transmitter will indicate an error by its indicator lights which will flash in
alternation.