Operation
Before Starting the Engine
100 100
9811/9950-1
Before Starting the Engine
P11-2002_2
Note: Read Operating in Low Temperatures or
Operating in High Temperatures in Operation section if
you will be using the machine in very cold or very hot
climates.
Note: If the fuel tank has been empty or if any part of the
fuel system has been drained or disconnected, the fuel
system must be primed before attempting to start the
engine. See Bleeding the System, Maintenance section.
!MDANGER
Before lowering the attachments to the ground, make
sure that the machine and the area around it are clear
of other people. Anyone on or close to the machine
could fall and be crushed by the attachments, or get
caught in the linkages.
2-2-3-4
1 Lower the excavator bucket and dozer to the ground,
if they are not already there. They will lower
themselves under their own weight when you operate
the controls. Operate the controls carefully to control
the rate of descent.
!MCAUTION
On machines fitted with hose burst protection valves
the attachments cannot be lowered with the engine
stopped. On these machines start the engine and
lower the attachments before doing the walk round
inspection.
2-2-3-5
2 For your own safety (and others) and for a maximum
service life of your machine, do a pre-start inspection
before starting the engine.
To Next Page
Loading...
Need help?
General
