Operation
Transporting the Machine
152 152
9811/9950-1
Unloading a Machine from the
Transporting Vehicle
1 Position the transporting vehicle on firm level ground.
2 Apply the park brakes and lower any stability jacks.
!MWARNING
Make sure that the ramp incline does not exceed the
machine's operational limits. See 'Working on Slopes'
for further details.
0133
3 Position the loading ramps securely on the
transporter.
Note: Ramps should be level with each other in the
lowered position.
4 Remove the securing straps from the machine and
stow them.
5 Start the machine and raise the bucket.
!MWARNING
If the dozer is to the rear, the track controls will be
reversed. Use extreme caution when tracking off the
trailer.
0136
6 Raise the dozer. Track slowly to the ramps.
7 Lower the boom until the bucket contacts the ground.
Continue to track forward until the tracks are over the
lowered ramps. Carefully raise the boom, allowing the
machine to rock onto the ramps.
8 Slowly drive off the transporter.
To Next Page
Loading...
Need help?
General
