Mulit-shot16
Continuous shot
Self-timer
Single shot
4746
11
After fixing the camera on the tripod, rotate the function dial
to and press the MENU button.
• The recording mode menu is displayed on the LCD monitor.
22
Press the or key so that [DRIVE MODE] is highlighted
and press the key.
33
Press the or key so that is [Self-Timer] highlighted
press to finish the setting.
• The drive mode changes in the as shown order.
The picture is taken about 10 seconds after the shutter-release button is pressed.
SELF-TIMER
66
Determine the image composition while looking into LCD
monitor or viewfinder and adjust the image range and size
with the or key.
• When the key is pressed, the image size becomes large (Telephoto mode),
When the key is pressed, the image range becomes wide (Wide-angle
mode).
77
Press the shutter-release button part-way down.
88
Press and hold the shutter-release button all-the –way down.
• When your finger is lifted from the shutter-release button or the maximum
number of picture is taken, the continuous shot is completed.
• When taking a continuous shot, the focus and exposure adjustments are
determined when the shutter-release button is pressed part-way down and
these adjustments are applied to all imaged in the continuous shot mode.
• Even after taking a sequence shot, the continuous shot mode capture is not
cancelled. The single shot mode returns when the camera is turned off and
on again.
BURST IMAGE CAPTURE -CONT'D
To Next Page
Loading...
Need help?
General