137136
CAUTIONS WHEN CONNECTING TO THE PERSONAL COMPUTER
• While this camera is connected to the computer or transferring the image data between this camera
and the computer, do not perform the following operations. Otherwise, the error may occur, the
camera and the computer may not function correctly, or the image data recorded in the CF card
may be erased or damaged.
• Turn off the power of the camera
• Disconnect the USB cable
• Rotate the function dial
• Remove or insert the CF card
On Windows2000 Professional, the data transfer is not actually completed due to the delay of writing
even when the display on the computer shows that copying is finished. As the data is transferred for a
while even after the copying message disappears, do not turn off the power of the camera, disconnect
the USB cable or rotate the function dial during the time. Otherwise, the error may occur, and the
camera and the computer not function correctly.
• When the camera is connected to the computer. The time for the auto power off function is fixed in
30 minutes automatically regardless of the power supply you use or the settings un the SETUP
mode (see page 113).
66
Install was successful.
77
Click the restart button to initial your sys-
tem.(suggests)
or click continue, if you wish to perform this
TWAIN driver immediately.
CONNECTING TO THE PERSONAL COMPUTER
To Next Page
Loading...
Need help?
General