Installation—Installing the FC-2000 11
11. Modules--Mount each module in its respective chassis position as
shown in Figure 19.
12. Field-wire each module, using the following figures for reference:
CPU-2000: Figures 23, 24, and 25
IZM-8 (Style B): Figure 26
IZM-8 (Style D): Figure 27
ICM-4/ICE-4: Figure 28
CRM-4/CRE-4: Figure 29
LCD-80, ACM-16AT/32A, ACM-8R, NIB-96, AA-30: Refer to the
Fire Management Accessories Manual (FAN 445).
TCM-2 and TCM-4: Refer to those documents in this manual.
VCM-4/VCE-4, DCM-4, AMG-1, FFT-7: For installation and field
wiring of voice alarm equipment, refer to the FC-2000 Fire Fighter’s
Command Center Technical Bulletin in this manual.
13. Power-on-check--Apply AC power to the system. Do not connect
the batteries at this time! To silence the audible trouble sounder, push
the ACKNOWLEDGE switch on the CPU. The system should reflect
the following status:
On the CPU:
● Green AC POWER indicator is on.
● SYSTEM TROUBLE and POWER FAILURE indicators will be
on due to the absence of batteries.
● ANNUNCIATOR or MODULE TROUBLE indicator may light
shortly after AC power is applied (applies only to a system that has
not been previously configured).
On each module
● The yellow trouble indicators may come on approximately
10 seconds after AC power is applied (applies only to a system
that has not previously been configured).
On each AVPS-24
● The yellow trouble indicators will light due to the absence of
batteries.
On the MPS-24A/B
● The BATTERY FAIL indicator will be on due to the absence of
batteries.
Failure of the AC POWER indicator, or the presence of indications
not mentioned above may suggest an installation problem. Carefully
review the installation instructions to isolate the source.
To Next Page
Loading...
Need help?
General
