Installation—Installing the FC-2000 5
In addition, the following equipment is required for the specific NFPA
standards listed below:
An NFPA-72 Remote Station Protected Premises Control Unit requires:
6. Sprinkler Supervisory service requires a CRM-4 Control Relay
Module and a cable assembly (Part No. 71270). Refer to the
Applications section of this document.
An NFPA-72 Proprietary Protected Premises Control Unit requires:
6. NIB-96 Network Interface Board. Refer to the Applications section of
this document. Not for sprinkler supervisory service.
An NFPA-71 Central Station Protected Premises Control Unit requires:
6. 911A Digital Alarm Communicator. Refer to the Applications section
of this document.
7. Sprinkler Supervisory and/or Waterflow Alarm service requires a
CRM-4 Control Relay Module. Refer to the Applications section of
this document.
An NFPA-72 Emergency Voice/Alarm Communication System requires:
6. VTCC-1, VCC-2 or VTCC-2 Voice/Telephone Command Center for
a voice evacuation system
7. AA-120 Audio Amplifier
8 VCM-4 Voice Control Module for up to four speaker or telephone
circuits or DCM-4 Dual Channel Module
Before proceeding, the installer should be familiar with the following
standards (as appropriate):
● NFPA 71 Installation, Maintenance, and Use of Central Station
Signaling Systems
● NFPA 72 Installation, Maintenance, and Use of Local, Auxiliary,
Remote Station, and Proprietary Protective Signaling Systems
● NFPA 72 Emergency Voice Alarm Service
● NFPA 72 Automatic Fire Detectors
● NFPA 72 Installation, Maintenance, and Use of Indicating Appliances
for Protective Signaling Systems
● NFPA 72 Testing Procedures for Signaling Systems
NFPA
Standards
To Next Page
Loading...
Need help?
General
