Chapter9 Appendix
VDR/S-VDR Real Time Monitor / Installation Manual
122
(9) Close the Hyper Terminal software, and restart the VDR IF by power switch.
(10) To check that the firewall became valid, input the “show” command as follows.
Since the VDR IF is restarted, open the command prompt screen again and check the firewall
after logging in the VDR IF.
If the "18firon.cfg" is displayed in the place of "Current configuration", firewall is valid.
(11) Write the attached IP address seal as follows, and stick it on the VDR IF.
VDR IF setup is completion above.
WAN：192.168.111.100 LAN：192.168.0.100
Manager vdr_if> show config Enter
Boot configuration file: 18firon.cfg (exists)
Current configuration: 18firon.cfg
To set firewall invalid, select the "18firof.cfg" as script file at the (8)
and cancel firewall of the VDR IF.
Note
To Next Page
Loading...
