3ņ77
3.6.3 Cancel Storing of Own Ship’s Track Data (Own Track Memory)
This function cancels the storing of own ship’s track data.
Procedure 1 Press [RADAR MENU] key.
Press [9] key.
Press [1] key.
The Own Track Setting Menu will appear.
2 Press [4] key.
The setting of Own Track Memory will be
switched between ON and OFF.
ON : Own ship’s track data is stored.
OFF : Own ship’s track data is not stored.
* Software button Õ¼ located at the bottom right corner of the radar display described in Section 2.3.4 is also
available for switching Track Data Storage Intervals. Setting the button to OFF cancels own track memory.
Note: The own ship’s track can be displayed even while Own Track Memory is set to OFF. In this
case, if rewrite operation such as changing of the display range is performed for the radar display,
the own ship’s track display is erased and the track is not plotted again.
If Display Own Track is set to OFF when Own Track Memory is ON, the own ship’s track is not
shown on the radar display but the system stores own ship’s track data at specified intervals.
To Next Page
Loading...
Need help?
General
