JRC JMA-5204 - Basic Menu Operation

3ņ7
3.2.2 Basic Menu Operation
To open the menu:
Press [RADAR MENU] key.
To close the menu:
Press [RADAR MENU] key.
Alternatively, hold down [0] key until the menu closes.
* Software button ղ located at the operation/message area in Section 2.3.9 also available to switch
between ON and OFF.
To move to a lower level of the menu:
The menu is in hierarchical structure. Press the numeric keys [1]-[9] corresponding to the desired
menu item number. Control will move to the lower level.
Alternatively, place the cursor over the item and then press [ENT] key.
> is shown at the right end of a menu item having a lower level.
To move to a higher level of the menu:
Press [0] key while the menu is open. Control will return to the higher level from the lower level.
Alternatively, place the cursor over the 0.EXIT item and then press [ENT] key.
To determine an item:
Press the numeric keys [1]-[9] corresponding to the desired item number. The selected item will be
displayed. Alternatively, place the cursor over the item you want to change, and then press [ENT]
key.
To determine the selected item:
Press the numeric keys [1]-[9] corresponding to the selected item number. Alternatively, place the
cursor over the selected item and then press [ENT] key. If you do not change the setting of the
selected item, press [CLR/INFO] key.