5.2 TT OPERATION
ņ18
5
yy
yyy
5.2.1 Acquiring Target [ACQ]
Target acquisition can be performed on two modes, AUTO and MANUAL, and both modes can be used at the
same time.
Automatic Acquisition [AUTO]
Procedure 1 Press the [AZ] key.
Automatic acquisition will be started. The mark “
” and target ID number are put to
an acquired target, and they move together with the target. The vectors are displayed
within one minute.
2 Press the [AZ] key again.
Automatic acquisition will be turned off, and automatic acquisition/activate zone
disappears from the radar display. However, automatically acquired ships are
continuously tracked.
For automatic acquisition/activate zone to be called by using the [AZ] key, refer to
“Setting Automatic Acquisition Key Assignment (Set AZ Key)” on the next page.
z If untracked targets intrude into automatic
acquisition/activate zone in the conditions that
maximum number of targets is under tracking, the
targets acquired automatically will be cancelled in
the order of lower levels of danger.
Attention
To Next Page
Loading...
Need help?
General
