ņ19
Setting Automatic Acquisition Key Assignment (Set AZ Key)
This section explains how to set automatic acquisition/activate zone that is to be assigned to the [AZ] key.
The setting enables the operator to select ON/OFF for a generally used automatic acquisition/activate zone by
simply operating the [AZ] key on the control panel.
Procedure 1 Press [TT MENU] key.
Press [5].
Press [3].
Press [1].
AZ menu will appear.
ON: Turns on automatic acquisition/activate
zone when the [AZ] key is pressed.
OFF: Does not turn on automatic
acquisition/activate zone when the [AZ]
key is pressed.
The same function also as RADAR Alarm (Sector Alarm) can be given.
Procedure 1 Press [TT MENU] key.
Press [5].
Press [3].
Press [2].
* The setting method is the same as the method of automatic acquisition/activate zone.
For the creation method of sector alarm, refer to [IV] “Make Sector Alarm (Make
Sector Alarm)” in Section 3.5.21 “Radar Alarm (Radar Alarm).”
To Next Page
Loading...
Need help?
General
