ņ21
7.2.7 Current Correction (SET/DRIFT) Setting
The current set and drift will be set.
Procedure 1 Press [RADAR MENU] key twice.
The Main Menu will appear.
2 Press [7] key.
The NAV Equipment Setting Menu will appear.
3 Press [6] key.
The Set/Drift Setting Menu will appear.
4 Press [1] key to enable Correction.
The setting of Correction is switched back and
forth between ON and OFF each time [1] key is
pressed.
Off : Do not perform current correction.
On : Perform current correction.
5 Press [2] key.
The Code Input Menu will appear.
6 Enter the direction of tendency.
The direction of tendency will be set. The multi-function control is also available for the
entry.
After having entered the direction, move the cursor onto the “ENT” button and press
[ENT] key.
7 Press [3] key.
The Code Input Menu will appear.
8 Enter the speed of tendency.
The speed of tendency will be set. The multi-function control is also available for the
entry.
After having enter the value, move the cursor onto the “ENT” button and press [ENT] key.
z The manually entered speed is effective only when
“Speed Equipment” is set to “Manual” or “LOG”.
Attention
To Next Page
Loading...
Need help?
General
