4-2-2. Reverse feed stitching (at start) pattern
A stitch shape of the reverse feed stitching (at start) is set by following the steps of procedure described
below.
(1) Enabling the reverse feed stitching (at start) pattern
①
Displaying the edit screen for reverse feed stitching (at start)
Keep
❸
held pressed for one sec-
ond. The reverse feed stitching (at start)
edit screen is displayed.
②
Setting the shape, the number of stitches and pitch of reverse feed stitching (at start)
Select the type of stitch with
❷
.
Select the edit item of the reverse feed
stitching (at start) with
❶
.
After the selection of the edit item, change
the numeric value with
❷
.
<Edit screen for reverse feed stitching (start)>
In the state pictograph
A
is displayed on
the screen, the reverse feed stitching (at
start) is enabled.
If pictograph
A
is not displayed on the
screen, press
❸
to display it to en-
able the reverse feed stitching (at start).
A
(2) Changing the number of stitches and pitch of reverse feed stitching (at start) pattern
Type of stitch Edit item
❸
❸
❶ ❷
– 31 –
To Next Page
Loading...
