– 23 –
Tighten (turn clockwise) oil amount adjustment screw ❶ to increase the amount of oil in the hook, or loosen
(turn counterclockwise) to decrease it.
❷
❹
❸
❶
Decrease
Increase
[When using RP hook (hook for dry head) for DDL-9000C-SMS type]
1. Remove hook driving shaft oil wick setscrew ❷ and attach hook driving shaft stopper screw
❸ (part number : 11079506) and rubber ring ❹ (part number : RO036080200).
2. Loosen oil amount adjustment screw ❶ up to the minimum so as to reduce the oil amount in
the hook. However, do not completely stop the oil and be careful not to allow oil adjustment
screw ❶ to come off.
3. Never drain the oil in the oil tank even when RP hook (hook for dry head) is used.
3-12-1. Adjusting the amount of oil in the hook
3-12. Adjusting the amount of oil (oil splashes) in the hook
WARNING :
Be extremely careful about the operation of the machine since the amount of oil has to be checked
by turning the hook at a high speed.
To Next Page
Loading...
