JUKI HZL-NX7 - Completing Manual 2-Step Buttonholes

109
❷
Buttonholes with gimp thread prevent the buttonholes from stretching and can make them more secure.
* A buttonhole with gimp thread should be sewn using the double bartack pattern (Pattern No.401)
1
Pass the needle thread through under the
presser foot and then draw the thread to
the side of the presser foot.
2
Put one end of gimp thread into the notch
❶
at the front right side of buttonhole
presser foot, pull the gimp thread under
the presser foot and thread it at the hook
❷
of the presser foot.
3
After threading at the hook, pull the gimp
thread back under the presser foot and
put it into the notch at the front left side of
the presser foot rmly.
4
Bring down the needle to the sewing start
point and lower the presser foot.
5
Sew the buttonhole.
6
Pull the left gimp thread to take off slack
and cut excess gimp thread.
❶
■
Buttonhole with gimp
No. Pattern Presser foot
401
Buttonhole presser foot
(E)
This stitch is used as basting for Pattern No. 401 Buttonholing.
It is also applicable to welt-buttonholing.
■
Basting stitch for buttonholing
No. Pattern
421
Leave the machine in
Lock mode