110
7.16. Manual 2-step buttonhole
1
Set the manual buttonhole presser foot (I).
2
Pass the needle thread through the hole
of the presser foot
❶
and pull it out
sideways together.
❶
❷
3
Bring down the needle on the sewing start
point
❷
and lower the presser foot.
* Refer to page 108 when you want to change the
zigzag width and stitch length of a buttonhole.
4
Push start/stop button to sew.
* At this time, if the start/stop button is pushed, the
machine will stop sewing. And if the start/stop but-
ton is pushed again, then the machine will continue
to sew the left side of the buttonhole.
Push the reverse stitch button
❹
when it
reaches the necessary length
❸
of the left
side of the buttonhole.
Sew bartack and the right side of the
buttonhole, then the machine sews
bartack and right side of the buttonhole.
❸
❹
No. Pattern
402
403
Presser foot
Manual buttonhole presser foot (I)
Leave the machine in Lock mode
To Next Page
Loading...
