34
Release the threading lever and the
needle thread is threaded to the needle
eye.
1
Lower the presser foot with the presser
foot lifting lever.
* The automatic needle threader sometimes fails
to thread the needle when the presser foot is
raised.
2
Thread to
7
and cut the thread with the
thread cutter
8
.
4
3
Lower the threading lever
9
until it comes
to a complete stop.
* Lower the threading lever slowly.
9
7
Lift the presser foot. Then, draw the
needle thread backward.
Pull out the thread from the needle eye by
approx.10 cm or 4 inches long.
5
■
Automatic needle threader
8
* Be careful that the
cutter is inside.
* When twin needle is used, the automatic needle
threader can not be used.
* Use the needle: No.11-16 and the thread: No.30-90.
To Next Page
Loading...
