JUKI HZL-NX7 - 4. Basic Settings and Operations; Connecting to Power Supply

16
4.1. Connecting to the power supply
●
Not-using foot-controller that using
start/stop-button:
②
Insert cord-connector
❷
into machine-socket-inlet
❶
.
Insert plug
❸
into socket-outlet.
●
Using the foot-controller:
②
Insert the foot-controller-plug
❺
into the foot-control-
ler-jack
❹
.
③
Insert cord-connector into machine-socket-inlet. Insert
plug into socket-outlet.
* When the foot controller is plugged in, the start/stop button
cannot be used to start sewing.
●
Start button: Can not operate to start sewing.
●
Stop button: Can operate to stop sewing.
WARNING
• Disconnect the plug and turn off the power switch (turn to “O”) that al-
ways sewing machine is not to use.
❹
❺
❶
❷
❸
4. Basic settings and basic operations
■
Connecting the codes
①
Turn OFF the power switch (turn to “O”)
WARNING (For U.S.A.,Canada only)
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug
is intended to t in a polarized outlet only one way. If the
plug does not t fully in the outlet, reverse the plug. If it
still does not t, contact a qualied electrician to install the
proper outlet. Do not modify the plug in any way.