JUKI HZL-NX7 - Stitch Parameter Adjustments; Adjusting Needle Position and Zigzag Width

42
4.16. Setting the automatic back tacking, thread trimming and
presser foot lifting
The back tacking at the beginning and end of sewing and the back tacking and thread trimming / presser foot lift after
thread trimming at the end of sewing can be set.
●
Display on the touch panel
ON OFF
Back tacking at the beginning
of sewing
Back tacking at the end of
sewing
Back tacking and thread trim-
ming
Presser foot lift after thread
trimming
Carry out basic setting of operations by
pressing
.
Back tacking and thread trimming
: OFF Thread trimming is not carried
out
: ON Thread trimming is carried out
Presser foot lift after thread trimming
: OFF The presser foot is not lifted
after thread trimming
: ON The presser foot is lifted after
thread trimming
* If a decorative pattern, etc. is set when the back
tacking at the beginning and end of sewing is se-
lected, reverse stitch will be changed over to back
tacking.
The set value is conrmed by pressing .
Setting for the back tacking at the
beginning of sewing
Select one from the three types of back
tacking.
: OFF : Reverse stitch
: Lock stitch
Setting for the back tacking at the end
of sewing
Select one from the three types of back
tacking.
: OFF : Reverse stitch
: Lock stitch