39
4.14. Setting the micro-lifter
Set the presser foot height to be employed by the micro-lifter
function by pressing the icon.
(Setting range: -2.5 - 0)
In the case it is not necessary to slightly lift the presser foot
during sewing, set the presser foot height for the micro-lifter
function to “0”.
Adjust the presser foot to the height at which the presser foot
appropriately clamp the material by pressing
.
The larger the negative set value becomes, the higher the
presser foot can be lifted.
Place the material (for trial stitching) that is the same with the
material to be actually sewn. Then, adjust the presser foot
height and carry out trial stitching.
Be aware, if the presser foot is lifted excessively during sew-
ing, the material cannot be fed resulting in thread entangle-
ment.
Press
.
Adjust the presser foot height on the “presser foot presser
setting screen”.
The set value is conrmed by pressing .
It is possible to sew the material with the presser foot slightly lifted according to the material thickness.
The micro-lifter function is used for sewing materials such as quilt and velvet that are likely to cause uneven material
feed.
To Next Page
Loading...
Need help?
General
