JUKI HZL-NX7 - Pattern Inversion (Horizontal and Vertical)

77
6.3. Types of edit functions and how to use them
6.3.1. Adjusting the darning
Carry out adjustment until the correct-
in-shape pattern can be sewn. Then,
nish adjustment.
The set value is conrmed by pressing
.
The darning pattern may be deformed according to the type and thickness of material, type of adhesive
interlining and sewing speed.
Before starting sewing of the pattern, trial stitching should be carried out under the same sewing condition
as the actual sewing to check whether the pattern is correctly sewn.
If it is found that the pattern is deformed during trial stitching, adjust the sewing condition as described below.
(1) Adjusting the darning of a pattern
In the case the selected pattern is found to be deformed
during trial stitching…
1. Press
.
2. Press
.
○
Correct shape
×
When right side
is higher than left
side
×
When right side
is lower than left
side
Carry out the adjust-
ment while conduct-
ing test sewing by
pressing
.
Carry out the adjust-
ment while conduct-
ing test sewing by
pressing .
3. The darning adjustment screen is displayed.