JUKI HZL-NX7 - Foot Switch and Start-up Settings

51
①
Standard thread tension setting
The machine can be set to the standard thread tension setting.
* Initial value has been factory-set to “0.0”.
Press .
Change the thread tension.
(Setting range: -5.0 - 5.0)
The set value is conrmed by pressing
.
②
Presser foot lifting height
The machine can be set to the presser foot lifting amount.
* Initial value has been factory-set to “6mm”.
Press .
Select the presser foot lifting amount.
The set value is conrmed by pressing
.
The needle thread
tension is decreased.
The needle thread
tension is increased.
The needle thread tension will
be returned to its initial value by
pressing the blue frame.
The needle thread tension
can also be adjusted by
sliding the slide bar to the
right or left.