111
5
Push reverse stitch button when it comes
to the sewing start point
❺
.
❺
6
Sew bartack and lock stitches until the
machine stops automatically.
Trim the thread. Lift the presser foot. Then, remove
the material from the sewing machine.
7
Pierce a stopper pin at the bartack and
open the buttonhole with a ripper
❻
.
Be careful not to cut the stitches.
* In the case of a 2-step buttonhole, sewing di-
rection of the left and that of the right side is
different. Due to this and according to fabrics to
be sewn, it may be possible that the density of
each side looks different.
❻
*
No. 403 In the case of 2-step buttonhole (Memory)
Since the length of a
buttonhole
that is sewn for the rst time is stored in memory, step of procedure
4
is not required for
buttonhole
for the 2nd time and beyond.
If you want to change the
buttonhole
length stored in memory, any other pattern should be selected.
To Next Page
Loading...
