JUKI HZL-NX7 - Lowering the Feed Dog

47
■
How to display the used amount
■
How to measure the amount of thread wound on a bobbin
The table given below indicates the amount of thread fully wound on the bobbin when the bobbin thread counter
is used. Use this table as the measure.
* This table should be used for reference since the amount of thread to be round on a bobbin may change ac-
cording to the type of thread to be used.
#30 #50 #60 #80 - #90 #100
Polyester
Spun
30m 50m 60m 70m 80m
33yd 55yd 66yd 77yd 87yd
Polyester
Filament
30m 70m 90m 100m 150m
33yd 77yd 98yd 109yd 164yd
Press to activate the used amount display.
Set the unit of the used amount by pressing
.
1) Inputting the bobbin winding amount
● In the case of inputting the measure of the amount
of thread to be wound on a bobbin
Find the measure of the amount of thread to be wound on
a bobbin according to the type and thickness of thread,
and set the appropriate numeric value.
● In the case of inputting the measured amount of
thread
Set the amount of thread to be wound on a bobbin using
the numeric value you have measured.
2) Inputting the ratio of thread amount remaining on a
bobbin with respect to the fully-wound amount
Estimate the amount of bobbin thread remaining on a
bobbin. Input the remaining thread amount in %.
(In the case the bobbin is fully wound with thread, the
percentage will be “100 %”.)
The set value is conrmed by pressing
.
Press to activate the measured amount display.
Set the unit of measured amount of thread by pressing
.
The set value is conrmed by pressing
.
Start measuring using the bobbin that is fully wound with
thread (i.e., 100 %)
The amount of thread displayed on the bobbin counter
icon when the bobbin runs out of thread represents the full
amount of thread to be wound on a bobbin.
1)
2)
The amount of thread used is displayed on the bob-
bin thread counter icon.
00m
The amount of thread remaining on the
bobbin is displayed on the bobbin thread
counter icon (in %).
When the ratio of thread remaining on
the bobbin becomes 20 % or less, the
percentage is displayed in red.