83
■
When changing the sewing direction
①
Stop the sewing machine when the position for chang-
ing the direction of sewing is reached.
②
If the needle is not penetrated into the material at that
position, press the needle up/down button to allow
the needle to penetrate into the material. Then, lift the
presser foot.
* The sewing machine has been factory-set at the
time of shipment, so that the needle penetrates into
the material when the sewing machine is stopped.
③
Change the direction of sewing with the needle pen-
etrated into the material. Then, lower the presser foot
and start sewing.
●
Presser foot pivot function
You can select the setting where the presser foot goes
up with the needle held in the needle-down stop position
when you stop the sewing machine.
: Pivot function is ON
: Pivot function is OFF
●
Changing over the needle stop position
It is possible to change the stop position to which is the
needle is brought when the sewing machine is stopped.
: The sewing machine stops with its needle up
: The sewing machine stops with its needle down
To Next Page
Loading...
Need help?
General
