95
* No. 035 In the case of bartacking (memory)
Since the length of a bartack that is sewn for the rst time is stored in memory, step of procedure
4
is not required for bartacking for the 2nd time and beyond.
If you want to change the bartack length stored in memory, any other pattern should be selected.
3
Start sewing.
Push the start/stop button and the machine starts to
sew straight stitches.
❸
Starting point
4
When it comes to the turning point
❹
push the reverse stitch button.
The machine goes back to the starting point by sewing
straight stitches and then it sews zigzag stitches to the
point where the reverse stitch button is pushed.
5
When the machine comes to the sewing
end point, push the reverse stitch button.
The machine sews lock stitches
❺
and stops.
❸
❹
❺
To Next Page
Loading...
