Jung Smart Control SC 1000 KNX - Page 36

Art. No. SC 1000 KNX
Objects for controller status
Function: Controller status
Object
h
90
Function
Controller status
Name
C.Output
Type
1-bit
DPT
1.001
Flag
C, -, T, (R)
1
Description 1-bit object for single status feedback of configured controller functions. This
object is only available in this way when a part of the controller status is to be
transmitted singly as 1-bit information (parameter-dependent).
Function: Controller status
Object
h
90
Function
Controller status
Name
C.Output
Type
1 byte
DPT
---
2
Flag
C, -, T, (R)
1
Description 1-byte object used by the controller to output the current state of operation.
Only when "Controller status" = "Controller general".
Function: Controller status
Object
h
90
Function
KNX status operating mode
Name
C.Output
Type
1 byte
DPT
20.102
Flag
C, -, T, (R)
1
Description 1-byte object used by the controller to output the current operating mode.
Only when "Controller status" = "KNX compliant".
Function: Controller status
Object
h
108
Function
Status signal addition
Name
C.Output
Type
1 byte
DPT
---
3
Flag
C, -, T, (R)
1
Description 1-byte object used by the controller to output the current enlarged state of
operation.
Only when "Controller status" = "Controller general".
Function: Controller status
Object
h
109
Function
KNX status
Name
C.Output
Type
2 byte
DPT
22.101
Flag
C, -, T, (R)
1
Description 1-byte object that the controller uses to display elementary basic functions in a
KNX-harmonised manner.
Only when "Controller status" = "KNX compliant".
1: For reading, the R-flag must be set. The last value written to the object via the bus or by the
device will be read.
2: Non-standardised DP type (in accordance with KNX AN 097/07 rev 3).
3: Non-standardised DP type.
Page 36 of 347
Software "Smart Control 501511"
Object table