Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
Function: Fan controller
Object
h
121
Function
Ventilation, fan level 7
Name
C.Output
Type
1-bit
DPT
1.001
Flag
C, -, T, R
Description 1-bit object for switching activation of the seventh fan level. This object is only
available when the fan control is to take place over 8 x 1 bit and at least seven
fan levels are enabled (parameter-dependent).
Function: Fan controller
Object
h
122
Function
Ventilation, fan level 8
Name
C.Output
Type
1-bit
DPT
1.001
Flag
C, -, T, R
Description 1-bit object for switching activation of the eighth fan level. This object is only
available when the fan control is to take place over 8 x 1 bit and at least eight
fan levels are enabled (parameter-dependent).
Function: Fan controller
Object
h
123
Function
Ventilation, forced position
Name
C.Input
Type
1-bit
DPT
1.001
Flag
C, W, -, (R)
1
Description 1-bit object for activation of the fan forced position. Polarity: Forced position
ON = "1"; Forced position OFF = "0".
Function: Fan controller
Object
h
124
Function
Ventilation, level limit
Name
C.Input
Type
1-bit
DPT
1.001
Flag
C, W, -, (R)
1
Description 1-bit object for activation of the fan level limitation. Polarity: Fan level limitation
ON = "1"; Fan level limitation OFF = "0".
Function: Fan controller
Object
h
125
Function
Ventilation, fan protection
Name
C.Input
Type
1-bit
DPT
1.001
Flag
C, W, -, (R)
1
Description 1-bit object for activating the fan protection. Polarity: Fan protection ON = "1" /
Fan protection OFF = "0".
1: For reading, the R-flag must be set. The last value written to the object via the bus or by the
device will be read.
Page 47 of 347
Software "Smart Control 501511"
Object table

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English